NCR S26 manual Install the PCI Ethernet Adapter in PCI slot

Sample RAID Configuration

8. Install the PCI Ethernet Adapter in PCI slot 3.

Configuring the System Settings

The procedure is the same as the procedure for configuring the system settings in the Standard Configuration. The procedure is repeated here for your convenience.

To configure the system settings, follow these steps:

1.Turn on power to the system. Observe that the memory test is executed (memory addresses should be rapidly displayed in upper left-hand corner of screen). Ignore any memory size mismatch error displayed on the screen.

2.Press Ctrl + Alt + Esc when prompted to enter the BIOS Setup Utility.

3.Select Load System Defaults and press Enter.

Basic System Configuration

1.Select Basic System Configuration. To go from page to page, press Page Down or Page Up.

2.Go to page 2 and set parameters as follows (in the order indicated):

Fast Boot Mode	[Disabled]
Auto Configuration Mode	[Disabled]
Memory Test	[Disabled]
Num Lock After Boot	[Enabled]
Large Memory Support	[Advanced]
On Board IDE	[Disabled]
Hard Disk Size > 504 MB	[Disabled]
Hard Disk Block Mode	[Disabled]

C-14 Sample Configurations