NCR S26 manual Keyboard Port

Sample Standard Configuration

1.Insert the EISA Configuration Utility in the diskette drive. Observe that the EISA Configuration Utility boots properly.

2.Select NCR 3426 Dual Pentium System from the Advanced Configuration menu.

Note: Refer to the “Viewing or Editing Configuration Details” section in Chapter 5 for additional information on configuring memory.

The PCI Adapter IRQ values entered below do not set the IRQ level for PCI Adapters.

Note: PCI Adapter IRQ settings are set in the BIOS Setup Utility. You enter the IRQ settings in the EISA Configuration Utility so that the EISA Configuration Utility does not assign IRQ values to EISA Adapters that have already been used for PCI Adapters.

Make sure the parallel port and serial ports are configured the same way as in the BIOS Setup Utility.

3. Configure the baseboard options as follows:

System BIOS Type	[RAM BIOS Enabled]
System Processor	[Pentium at 166 MHz]
Special System Parts	[Special System Parts]
EISA Reserved Devices	[EISA Reserved Devices]
System Memory Function
Base System Memory	[640K Base Mem]
8-16 MB System Memory	[16 MB System Memory]
16-64 MB System Memory	[Enabled]

Note: You should manually configure the system memory by enabling appropriate memory ranges and using Ctrl + R to configure the memory site within these memory ranges.

Mouse Port	[Enabled]
Keyboard Port	[Enabled]
Floppy Disk Controller	[Enabled]

NCR S26 Hot Plug Server User Guide C-11