Oki 56801 manual Changing User Function Settings, Setting Distinctive Ring

26: RESTRICT ACCESS: Select whether or not you want

restricted access. Turning on this function renders your restricted

ID registration active. Available settings are On and Off.

27: WIDTH REDUCTION: Turning this function on enables you

to print received data at a slightly reduced width.

28: TONER SAVE: This function allows you to select whether

to use toner saving during facsimile printing. The settings are On

and Off.

29: CNG COUNT: This function allows you to switch to a

facsimile reception mode at a certain CNG signal quantity (1-5)

when the unit is operating in T/F.

30: 600DPI FAX TX: This function sets whether to enable 600-

4.Using the numeric keypad, enter the 2-digit number of the function you want to change. This display then shows the name of the selected function.

5.Press the NO key to cycle through the settings for the user function, then press the YES key to confirm your selection. The name of the next user function appears in the display.

6.Press the Select Function key to finish or the Stop key to back out.

Note: As an example for changing the settings, see Setting Distinctive Ring.

Setting Distinctive Ring

DPI read when Ex. FINE is selected for TX RESOLUTION. The

settings are On and Off.

Changing User Function Settings

SELECT

FUNCTION

9/OP

USER

PROG.

1: FUNC.PROGRAMMING

YES

SELECT

FUNCTION

9/OP

USER

PROG.

1: FUNC.PROGRAMMING

YES

Note: In some countries, distinctive ring service is not available from the local telephone company.

1.Press the Select Function key.

2.Press the 9/User Prog. One-Touch key. The display shows

1.Press the Select Function key.

2.Press the 9/User Prog. One-Touch key. The display shows

1:FUNC. PROGRAMMING.

3. Press the YES key. The display shows FUNCTION NO. [ ].

1:FUNC. PROGRAMMING.

3.Press the YES key. The display shows FUNCTION NO.[ ].

4.Using the numeric keypad, enter 12. The display shows 12:DISTINCTIVE RING and its current setting OFF.

5.Press the NO key to change the setting to SET.

57