Q-Logic 5602 manual Error rate has fallen below the falling trigger

A

13 – Command Reference Set Config Threshold

Notes	The switch will down a port if an alarm condition is not cleared within three
	consecutive sampling windows (by default 30 seconds). Reset the port to bring it
	back online. An alarm is cleared when the threshold monitoring detects that the
	error rate has fallen below the falling trigger.
Examples	The following is an example of the Set Config Threshold command:
	SANbox #> admin start
	SANbox (admin) #> config edit
	SANbox (admin-config) #> set config threshold
	A list of attributes with formatting and current values will follow.
	Enter a new value or simply press the ENTER key to accept the current				value.
	If you wish to terminate this process before reaching the end of the list
	press 'q' or 'Q' and the ENTER	key to do so.
	ThresholdMonitoringEnabled	(True / False)		[False	]
	CRCErrorsMonitoringEnabled	(True / False)		[True	]
	RisingTrigger	(decimal value,	1-1000)	[25	]
	FallingTrigger	(decimal value,	0-1000)	[1	]
	SampleWindow	(decimal value,	1-1000 sec) [10		]
	DecodeErrorsMonitoringEnabled	(True / False)		[True	]
	RisingTrigger	(decimal value,	1-1000)	[25	]
	FallingTrigger	(decimal value,	0-1000)	[0	]
	SampleWindow	(decimal value,	1-1000 sec) [10		]
	ISLMonitoringEnabled	(True / False)		[True	]
	RisingTrigger	(decimal value,	1-1000)	[2	]
	FallingTrigger	(decimal value,	0-1000)	[0	]
	SampleWindow	(decimal value,	1-1000 sec) [10		]
	LoginMonitoringEnabled	(True / False)		[True	]
	RisingTrigger	(decimal value,	1-1000)	[5	]
	FallingTrigger	(decimal value,	0-1000)	[1	]
	SampleWindow	(decimal value,	1-1000 sec) [10		]
	LogoutMonitoringEnabled	(True / False)		[True	]
	RisingTrigger	(decimal value,	1-1000)	[5	]
	FallingTrigger	(decimal value,	0-1000)	[1	]
	SampleWindow	(decimal value,	1-1000 sec) [10		]
	LOSMonitoringEnabled	(True / False)		[True	]
	RisingTrigger	(decimal value,	1-1000)	[100	]
	FallingTrigger	(decimal value,	0-1000)	[5	]
	SampleWindow	(decimal value,	1-1000 sec) [10		]

Finished configuring attributes.

This configuration must be saved (see config save command) and activated (see config activate command) before it can take effect.

To discard this configuration use the config cancel command.

59183-01 A 13-73