Q-Logic 5602 manual Set Config Port, Keywords port portnumber, Ports portnumber

A

13 – Command Reference Set Config Port

Set Config Port

Sets the port configuration parameters for one or more ports. The changes you make with this command are not retained when you reset or power cycle the switch unless you save them using the Config Save command.

Authority Admin session and a Config Edit session

Syntax set config port [port_number]

or

set config ports [port_number]

Keywords port [port_number]

Initiates an edit session in which to change configuration parameters for the port number given by [port_number]. If you omit [port_number], the system begins with port 0 and proceeds in order through the last port. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets. Enter “q” to end the configuration for one port, or “qq” to end the configuration for all ports. Table 13-14describes the port configuration parameters.

ports [port_number]

Initiates an editing session in which to change configuration parameters for all ports based on the configuration for the port given by [port_number]. If you omit [port_number], port 0 is used. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets. Enter “q” to end the configuration. Table 13-14describes the port configuration parameters.

	Table 13-14. Port Configuration Parameters
Parameter		Description
AdminState		Port administrative state:
		„ Online – Activates and prepares the port to send data.
		This is the default.
		„ Offline – Prevents the port from receiving signal and
		accepting a device login.
		„ Diagnostics – Prepares the port for testing and prevents
		the port from accepting a device login.
		„ Down – Disables the port by removing power from the
		port lasers.
LinkSpeed		Transmission speed:
		„ 1/2/4-Gbps Ports: 1-Gbps, 2 Gbps, 4-Gbps, or Auto. The
		default is Auto.
		„ 10-Gbps Ports: 10-Gbps or Auto. The default is Auto.

59183-01 A 13-61