13 – Command Reference Set Setup SNMP
S
Set Setup SNMP
Configures SNMP on the switch.
Authority | Admin session |
Syntax set setup snmp
Prompts you in a
Table 13-22. SNMP Configuration Settings
Entry | Description |
|
|
SNMPEnabled | Enables (True) or disables (False) SNMP on the switch. The |
| default is True. |
Contact | Specifies the name of the person to be contacted to respond to |
| trap events. The name can be up to 64 characters excluding #, |
| semicolon (;), and comma (,). The default is undefined. |
Location | Specifies the name of the switch location. The name can be up |
| to 64 characters excluding #, semicolon (;), and comma (,). |
| The default is undefined. |
Trap | Specifies the workstation IP address to which SNMP traps are |
| sent. The default address for trap 1 is 10.0.0.254. The default |
| address for traps |
| for all traps must be unique. |
Trap | Specifies the workstation port to which SNMP traps are sent. |
| Valid workstation port numbers are |
| 162. |
Trap | Specifies the severity level to use when monitoring trap events. |
| The default is Warning. |
Trap | Specifies the SNMP version (1 or 2) to use in formatting traps. |
| The default is 2. |
Trap | Specifies whether traps (event information) are enabled or dis- |
| abled (default). |
ReadCommunity | Read community password that authorizes an SNMP agent to |
| read information from the switch. This is a |
| value on the switch and the SNMP management server must |
| be the same. The read community password can be up to 32 |
| characters excluding #, semicolon (;), and comma (,). The |
| default is “public”. |
|
|
|