Q-Logic 5602 manual Configuring the Security Database, Set Config Security command

A

9 – Device Security Configuration Configuring the Security Database

9.2

Configuring the Security Database

You can configure how the security database is applied to the switch and exchanged with the fabric through the security configuration parameters. The following security configuration parameters are available through the

Set Config Security command:

„AutoSave–This parameter enables or disables the saving of changes to active security set in the switch’s non-volatile security database.

„FabricBindingEnabled–This parameter enables or disables the configuration and enforcement of fabric binding on all switches in the fabric. Fabric binding associates switch worldwide names with a domain ID in the creation of ISL groups.

If AutoSave is False, you can revert device security changes that have been received from another switch through the activation of a security set, or merging of fabrics. Enter the Security Restore command to replace the volatile security database with the contents of the non-volatile security database.

To restore the security configuration to its factory values, you can enter the Reset Config or Reset Factory command. Notice however, that these commands restore other aspects of the switch configuration also.

59183-01 A 9-7