105
Additional Information / Información complementaria
CCD-TR2200E/TR3300E 3-856-204-12 (1)
English
If you run into any problem using the camcorder, use the following table to troubleshoot the problem.
Should the difficulty persist, disconnect the power source and contact your Sony dealer or local
authorized Sony service facility.

Camcorder

Power

Symptom
The power is not on.
The power goes off.
The battery pack is quickly
discharged.
The beep sounds when the battery
is attached.
START/STOP does not operate.
Cause and/or Corrective Action
•The battery pack is not installed.
mInstall the battery pack. (p.11)
•The battery is dead.
mUse a charged battery pack. (p.8)
•The AC power adaptor is not connected to the mains.
mConnect the AC power adaptor to the mains. (p.27)
•You use other types of battery except NP-F530/F730.
•While being operated in CAMERA mode, the camcorder has
been in Standby mode for more than 5 minutes.
mTurn STANDBY down once and then up again. (p.14)
•The battery is dead.
mUse a charged battery pack. (p.8)
•If the VF PW-SAVE is set to ON in the menu system, the picture
disappears automatically when you turn your face away from the
viewfinder. (CCD-TR3300E only)
mBring your face close to the viewfinder within 1 cm (1/2 in).Or
set VF PW-SAVE to OFF in the menu system. (p.32)
•The ambient temperature is too low.
•The battery pack has not been charged fully.
mCharge the battery pack again. (p.8)
•The battery pack is completely dead, and cannot be recharged.
mUse another battery pack. (p.11)
•You use other types of battery except NP-F530/F730.
•The battery pack is discharged during a long period of storage.
mCharge the battery pack again. (p.8)
•The tape is stuck to the drum.
mEject the tape. (p.12)
•The tape has run out.
mRewind the tape or use a new one. (p.23)
•The POWER switch is set to PLAYER.
mSet it to CAMERA. (p.13)
•The tab on the cassette is out (red).
mUse a new tape or slide the tab. (p.12)
Trouble check
(to be continued)