10 Main Menu

SCAN BAR

CALIBRATION TEST

PRESS START TO BEGIN

Scan Bar Screen

8.Press the Start key to begin the test. While the test is executing, the bottom display line changes to “RUNNING.”

At the completion of the test, the test result is displayed. A test result with no failure displays as PASSED. A test result with a failure displays as FAILED followed by ERROR CODE: and a hexadecimal value between 0 and FF. If a failure code is displayed, call for service.

9.Press the Exit key to return to the SCANNER DIAGNOSTICS menu screen.

Full System Test

Select the FULL SYSTEM TEST option to run all applicable tests on the Scan System to determine if it is working properly.

To run the FULL SYSTEM TEST diagnostic:

1.Press the Menu key. The MAIN MENU screen is displayed.

2.Press the Next key until DIAGNOSTICS is highlighted.

3.Press the Enter key to select DIAGNOSTICS. The DIAGNOSTICS menu screen is displayed.

4.Press the Next key until SCANNER DIAGNOSTICS is displayed.

5.Press the Enter key to select SCANNER DIAGNOSTICS. The SCANNER DIAGNOSTICS menu screen is displayed.

6.Press the Next key until FULL SYSTEM TEST is highlighted.

7.Press the Enter key to select FULL SYSTEM TEST. The FULL SYSTEM TEST screen is displayed.

FULL SYSTEM TEST

A) B) C) D) E) F)

G) H) I)

PRESS START TO BEGIN

Full System Test Screen

Nine sub-tests are included in the system test. Each letter on the screen corresponds to a sub-test as follows:

a)Post Test 5 – NVM (Non Volatile Memory) Verification

b)Post Test 6 – Motor Communications

c)Post Test 7 – SCVM Code Checksum

d)Post Test 8 – SCVM (Scan System Virtual Memory) Load and Functional Test

128

Wide Format Copy System User Guide

Page 134
Image 134
Xerox 6279, 5101 manual Scan BAR Calibration Test Press Start to Begin, Scan Bar Screen, Full System Test Screen