
2 Getting to know the Wide Format Copy System
The Printer and the FreeFlow Accxes Controller
For detailed operating instructions about the Printer and Controller components of the Wide Format Copy System and about network connectivity, refer to the documentation listed below.
yFreeFlow Accxes System & Web Printer Management Tool Setup Guide
yFreeFlow Accxes Controller Service Manual for HFT/PUN
yXerox FreeFlow Accxes Controller Service Manual for YKE/
Powering On the Wide Format Copy System
To power on the XEROX Wide Format Copy Systems, you first must switch on the Scan System and wait for 30 seconds or check that a “P” is displayed on the status LED in the back of the Scan System. Then switch on the Printer, then the Controller.
Follow the instructions provided in this section for your system.
Initial Power-On
For all controllers except the YKE,
The default for this parameter is disabled. You must ensure that it is set to Enabled when powering on the Xerox Wide Format SCAN SYSTEM for the first time. After setting the DDS parameter, wait 30 seconds, and then power the system off then on. Once you enable this parameter, it will remain enabled (even following future software upgrades).
For the Xerox Wide Format Copy System 510 Series, you can set this parameter from either the CONTROLLER CONFIGURATION screen of the Printer Control Panel or on the Web Printer Management Tool. For the Xerox Wide Format Copy System 6030/6050/6050A, 721P, 6204, and 6279 you can only set this parameter from the Web Printer Management Tool, (Configuration > Printer > Printer Setup > DDS Enabled).
30 | Wide Format Copy System User Guide |