Chapter 4
example, you cannot use the HP
Figure 4-6 Back view of the HP All-in-One
1Telephone wall jack
2Use the phone cord supplied in the box with the HP
3Computer with modem
To set up the HP All-in-One with a computer dial-up modem
1.Remove the white plug from the port labeled
2.Find the phone cord that connects from the back of your computer (your computer
3.Using the phone cord supplied in the box with the HP
NOTE: If you do not use the supplied cord to connect from the telephone wall jack to the HP
4.If your modem software is set to receive faxes to your computer automatically, turn off that setting.
NOTE: If you do not turn off the automatic fax reception setting in your modem software, the HP
5.Turn on the Auto Answer setting.
6.(Optional) Change the Rings to Answer setting to the lowest setting (two rings).
7.Run a fax test.
When the phone rings, the HP
36 Finish setting up the HP