Solution: Check the display or your computer for an error message providing information about the problem and how to solve it. If there is an error, the HP
You can also check the status of the HP
For more information on error messages, see Errors.
Cause: You are using either a PBX or an ISDN converter/terminal adapter.
Solution:
•Make sure the HP
NOTE: Some ISDN systems allow you to configure the ports for specific phone equipment. For example, you might have assigned one port for telephone and Group 3 fax and another port for multiple purposes. If you have problems when connected to the fax/phone port of your ISDN converter, try using the port designated for multiple purposes; it might be labeled "multi- combi" or something similar.
•Try setting the Fax Speed to Medium or Slow.
Cause: The Fax Speed setting is set too fast.
Solution: You might need to send and receive faxes at a slower rate. Try setting the Fax Speed to Medium or Slow if you use one of the following:
•An Internet phone service
•A PBX system
•Fax over Internet Protocol (FoIP)
•An ISDN service
To set the fax speed from the control panel
1.Press Setup.
2.Press 5, and then press 7.
This selects Advanced Fax Setup and then selects Fax Speed.
3.Press to select one of the following settings, and then press OK.
Fax speed setting
Fast
Medium
Slow
Fax speed
v.34 (33600 baud)
v.17 (14400 baud)
v.29 (9600 baud)
Cause: The HP
Fax troubleshooting | 175 |