ADTRAN 810 Plus manual Quad T1/PRI Module Network Termination/NFAS

Chapter 9. Dial Plan Terminal Menu

»»Outgoing Caller ID Write Security: 3 Read Security: 5

Inserts a called ID based on the following selections:

Send as provided	ATLAS forwards whatever ID it receives (including None).
Substitute if not	ATLAS inserts a User-defined ID value if no value is received.
present
ID Presentation	Sends to the Network control information for the presentation of Caller ID
	(Presentation Allowed; Presentation Restricted; Number Not Available).
ID Number	Value for Caller ID to be sent to the Network (i.e., 256 963 8020).
Substitute always	ATLAS always inserts the User-defined ID in place of the value received.
ID Presentation	Same as above.
ID Number	Same as above.
»» Source ID	Simplifies the creation of a Dial Plan in applications where the criterion for
	switching calls to a certain endpoint is a function of which endpoint origi-
	nated the call.
	• Default value = 0. The default ID for all endpoints is 0 and for all accept
	# s is 0. With default values, all calls are routed based only on dialed
	number.
	• Multiple endpoints can have the same Source ID.
	• When creating the Call Accept list, specify a Source ID(s) as well as a
	dialed number or range of dialed numbers to accept.
	Say, for example, an application requires that all calls originating from
	Port 1 of the Quad T1/PRI module in Slot 1 be switched to Port 4 of that
	same module. Assign a unique Source ID (e.g., 7) to Port 1 of the module,
	and then configure Port 4 to only accept calls from that unique Source ID
	(7).
»» Swap ANI/DNIS	Swaps the ANI and DNIS numbers received from the Network. ANI (Auto-
	matic Number Identification) is the billing number of the calling party, and
	DNIS (Dialed Number Identification Service) is the called party number.
	This swap causes the ATLAS switchboard to use ANI to route the
	call. The accept number in the Dial Plan must use the ANI number,
	not the DNIS number.

Quad T1/PRI Module (Network Termination/NFAS)

When you are working in the Network Termination section of the Dial Plan menu, Slot is defined as a T1/PRI module, and Sig is set to NFAS, the fol-

9-12 ATLAS 810PLUS User Manual 61200266L1-1