ADTRAN 810 Plus Updating Firmware using Xmodem, Instructions for Updating Firmware Using Xmodem

Chapter 10. Updating Firmware

Updating Firmware using XMODEM

Before beginning this procedure,

•you must have a level 2 password for updating any module within ATLAS 810PLUS. Please consult the ATLAS 810PLUS administrator if you do not know the password.

•you must obtain the appropriate update file for the particular module from ADTRAN Technical Support at (888) 4ADTRAN (423-8726).

•you may want to review Update Firmware on page 6-16.

	Instructions for Updating Firmware Using XMODEM
Step	Action
	Using a VT-100 terminal emulation communication software
1	package which contains XMODEM protocol support, log in to
	ATLAS 810PLUS.
2	Select System Utility / Update Firmware (see Figure 10-1).
	Move the cursor to Module Slot, and press Enter. Select the
	appropriate module slot to update. To update multiple modules of
3	the same type, select All Modules of a Type from Module Slot.
	(Only upgradable modules are displayed as choices for Module
	Type when updating All Modules of a Type in the ATLAS.)
4	Select XMODEM for Transfer Method.
	From Restart Schedule, select the time for the module to perform
5	a restart after completing the update process (see Restart
	Schedule on page 6-17).
	View Current Update Status to verify the progress of the current
6	firmware update or any errors encountered during the download
	process (see Current Update Status on page 6-18).
	Select Begin Firmware Update to start the update process. Enter
	Y to confirm the transfer and to set up the module to receive the
	XMODEM upload.
7	When ATLAS is ready to receive the XMODEM upload, the menu
	screen will clear and display Awaiting XMODEM Upload…… <CTRL-
	X> to Cancel. If this does not appear, please review the steps
	above for possible configuration errors.

10-2 ATLAS 810PLUS User Manual 61200266L1-1