ADTRAN 810 Plus »» Authen Trap, Transmission, »» Traps Destination, Community, Trap Filtering

Chapter 6. Terminal Menu and System Control

»»Trap Transmission Write security: 3; Read security: 5

Enables and disables SNMP trap transmission.

»» Authen Trap	Write security: 3; Read security: 5
Transmission	Enables and disables the authentication failure trap.
»» Traps Destination	Write security: 3; Read security: 5
	Defines the destination for SNMP traps as follows:
IP Address	Identifies the IP address to which the network manager sends traps.
Community	Defines the community name for trap destinations. This name must match
	the community name defined at the network management station.
Trap Filtering	Sets the minimum severity level required for a system event to generate an
	SNMP trap.
	If a trap event occurs and if the trap’s severity level is equal to or more severe
	than the trap type’s current threshold setting, that event is sent as an SNMP
	trap. (Refer to the ATLAS 810PLUS MIB for a listing of all traps and their se-
	verity levels.) You can set the following threshold levels for the available se-
	lections: disabled, critical, major, minor, warning, normal, and info.
Station Type	Trap packets destined for the T-Watch GUI-based management station re-
	quire “.ADLP ADDRESS” to be appended to the Community Name. Defin-
	ing the Station Type to “T-Watch Mgmt” will automatically update this field
	within the SNMP trap packet before sending it to the management station.
	Defining the Station Type to “Normal” will deliver the SNMP trap packet
	with the Community Name unchanged.

»»DS1 Current Perf TD Defines performance threshold values for DS1 Line and Path statistics re- corded in a 15-minute interval. If a statistic value exceeds its threshold value, then the corresponding Alert Trap will be sent if the alert event is armed and Alert Traps are enabled. These thresholds apply to all DS1 interfaces in the system.

Current ES Thrsh The DS1 performance monitor Threshold Value for the Current 15 minute Errored Seconds (ES) parameter. The default value is 65 for an approximate BER level of 10E-5.

Current SES Thrsh The DS1 performance monitor Threshold Value for the Current 15 minute Severely Errored Seconds (SES) parameter. The default value is 10 for an ap- proximate BER level of 10E-5.

Current SEFS Thrsh The DS1 performance monitor Threshold Value for the Current 15 minute Severely Errored Framing Seconds (SEFS) parameter. The default value is 2 for an approximate BER level of 10E-5.

Current UAS Thrsh The DS1 performance monitor Threshold Value for the Current 15 minute Unavailable Seconds (UAS) parameter. The default value is 10 for an ap- proximate BER level of 10E-5.

6-10 ATLAS 810PLUS User Manual 61200266L1-1