
Chapter 4 Using the Front Panel
OVERVIEW
The front panel contains the System LED, the Alarm
status LEDs that provide visual information about the ATLAS 810PLUS Base Unit and any option module that may be installed. Figure
Controller Status |
|
|
|
|
|
|
|
|
|
| |
LEDs |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ATLAS 810PLUS | Module Slot | |
|
|
|
|
|
|
|
|
|
|
| |
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
|
| Numbers |
OK | STATUS |
|
|
|
|
|
|
|
|
|
|
TEST | ONLINE |
|
|
|
|
|
|
| SYSTEM |
| CRAFT |
ERROR | TEST |
|
|
|
|
|
|
|
|
| |
ALARM |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| Port | |
CONTROLLER |
|
|
| MODULES |
|
|
| ACO | CRAFT | ||
|
|
|
|
|
|
|
|
|
|
| Alarm |
|
|
|
|
|
|
|
|
|
|
| Switch |
| Module Status |
|
|
|
|
|
|
| |||
|
| LEDs |
|
|
|
|
|
|
|
|
Figure 4-1. ATLAS 810PLUS Front Panel Layout
SYSTEM LED
The System LED indicates the general status of the entire ATLAS 810PLUS (see also System LED in Table
ACO SWITCH
The ACO switch deactivates (clears) the Alarm Relay, located on the rear
panel of the ATLAS 810PLUS, after an alarm condition has occurred. After the ACO has cleared the Alarm Relay, the same occurrence no longer trig- gers the Alarm Relay. However, if the alarm condition is corrected and then reoccurs, the Alarm Relay will
ATLAS 810PLUS User Manual |