
Chapter 9. Dial Plan Terminal Menu
Quad Nx56/64 Module (User Termination)
The Quad Nx56/64 can only serve as a User termination endpoint.
| When you are working in the User Termination section of the Dial Plan |
| menu, and Slot is defined as a QuadNx56/64 module, the following inter- |
| face configuration options are available: |
»» Ports Available | Indicates which of the four ports of the Quad Nx56/64 module have |
| already been defined either in another switched endpoint (indicated by “s”) |
| or in a dedicated map (indicated by “n”). This field is |
»» Number of Ports | Defines to ATLAS how many of the ports could be used to answer calls to |
| the number(s) defined in the Accept Call list. You can enter numbers 1 |
| through 4. The ports are contiguous beginning with the port number select |
| and the number of ports. |
| For example, if the port selected (as a part of Slot/Port selection) is 2, and |
| the number of ports selected here was 2, then ports 2 and 3 would be |
| enabled to receive calls to the numbers listed under the Incoming Call |
| Accept list. |
Octal BRI Module (Network Termination)
| The Octal BRI with a “U” interface can interface directly to the Network |
| (PSTN). When you are working in the Network Termination section of the |
| Dial Plan menu and Slot is defined as a |
| ing interface configuration options are available: |
»» Switch Type | Write security: 2; Read security: 5 |
| Defines the type of ISDN switch that ATLAS is connected to. If connected to |
| another ATLAS, both need to be set to the same type. The available options |
| are Lucent 5E, Northern DMS 100, and National ISDN. |
»» SPID List | Write security: 2; Read security: 5 |
| In order to properly operate with a network (PSTN) ISDN switch, the BRI in- |
| terface must have SPID (Service Profile Identifier) and phone number(s) that |
| match the SPID(s) and phone number(s) which have been programmed into |
| the ISDN switch for this line. Each BRI may have one or more phone num- |
| bers and SPIDs. The SPID Number list submenu defines to ATLAS these pa- |
| rameters. |
Phone Number | The phone number(s) assigned to this BRI phone line. |
SPID Number | This entry must match the SPID number(s) which have been set in the Net- |
| work’s ISDN switch (or in the PBX) for this BRI line. A SPID must be entered |
| for each phone number. |
ATLAS 810PLUS User Manual |