
| Chapter 6. Terminal Menu and System Control |
|
|
» Chain Port | Write security: 2; Read security: 5 |
| Accepts input for configuring the Chain In port. |
»» Port Name | Write security: 2; Read security: 5 |
| Defines the name of the chain port. Type in an |
| characters long. The name can include spaces and special characters. |
»» Port Type | Write security: 2; Read security: 5 |
| Specifies whether you use Direct or Dial mode. |
»» Port Speed | Write security: 2; Read security: 5 |
| Specifies the baud rate of the port. Select either 2400, 9600, 19200, or 38400. |
| If you are using Dial for Port Type, ensure that the Port Speed setting |
| matches the modem baud rate. |
»»Modem Initialization Write security: 2; Read security: 5
String | Specifies the initialization string for a modem. Refer to your modem docu- |
| mentation for acceptable initialization strings. |
»» Initialize Modem | Write security: 4; Read security: 5 |
| Sends the Modem Initialization string to the modem. When you select this |
| command, the following message displays: Please verify a modem is con- |
| nected to the chain port before continuing. Confirm (y/n).ýEnsure that a |
| modem is connected before selecting Y. |
»» Flow Control | Write security: 2; Read security: 5 |
| Sets the flow control for the Chain In port. You may configure the Chain In |
| port flow control for OFF or H/W (hardware). |
» SNMP | Write security: 3; Read security: 5 |
| Provides a way to configure SNMP access for the ATLAS 810PLUS. For |
| detailed information on SNMP, refer to SNMP Management on page |
| The following options are available for review and editing: |
»» SNMP Access | Write security: 3; Read security: 5 |
| Defines whether SNMP access to the ATLAS 810PLUS is enabled or disabled. |
| Select the appropriate option. |
»» SNMP Communities | Write security: 3; Read security: 5 |
| Defines SNMP manager(s) characteristics as follows: |
IP Address | Specifies the IP address of the network manager. |
Privileges | Defines Get |
Get Name | Defines the community name for Get access. This value must match the Get |
| name defined on the network management station. Public is the default |
| name. |
Set Name | Defines the community name for Set access. This value must match either |
| the Get or Set name defined on the network management station. Public is |
| the default name. |
ATLAS 810PLUS User Manual |