ADTRAN 810 Plus manual »» Save Config, Remotely, Server in Tftp Server IP Address, »» Selftest Run

Chapter 6. Terminal Menu and System Control

»» Save Config	Write security: 3; Read security: 5
Remotely	Saves the configuration file specified in TFTP Server Filename to the
	server identified in TFTP Server IP Address. To start this command, enter
	Y to begin or enter N to cancel.

Before using this command, you must have identified a valid TFTP

Server in TFTP Server IP Address.

»System Utilization Write security: 0; Read security: 0

Displays statistics related to the ATLAS internal operating system. Please check with ADTRAN Technical Support before attempting to use this menu.

»System Selftest Write security: 3; Read security: 5

Initiates a system self-test. The self-test consists of memory tests and data integrity tests for each installed module.

Self-tests disrupt data flow.

»» Selftest Run	Write security: 3; Read security: 5
	Runs system-wide selftest, Memory, Flash, Bootrom, and Port Tests. These
	tests are disruptive to all data traffic; therefore, do not run these tests on a
	unit unless data interruptions are acceptable. To confirm self-test activation,
	press Y; to cancel the self-test press N.
»» Current Test Status	Security level: 3; Read security 5
	Indicates a system self-test. The self-test consists of memory tests and data
	integrity tests for each installed module.

»»Current Slot/Port Displays slot and port of the subsystem currently being tested.

6-20 ATLAS 810PLUS User Manual 61200266L1-1