ADTRAN 810 Plus manual Instructions for Defining the IP Address, Step Action

Chapter 3. Operation

Instructions for Setting Up an ATLAS 810PLUS for VT-100 Terminal Mode

Step Action

1Set the baud rate on the VT-100 terminal to 9600 baud (8/N/1).

Use the ADTRAN-provided VT-100 terminal adapter to connect the COM port of a VT-100 compatible terminal, or equivalent, to

2	the eight-pin modular jack labeled CONTROL/CHAIN IN on the
	rear panel or labeled CRAFT on the front panel.
	This connection provides both local and remote configuration.
3	Repeatedly press Enter on the keyboard until the Login menu
	requiring a password appears.

4If necessary, press Ctrl-Rto refresh the display.

When you begin the VT-100 session, you will be prompted for a password. The default password is password (which is a Level 0 superuser password). You can change this password using the Access Passwords option, which is only accessible through the terminal menu. See Access Passwords on page 6-13for details. After your password is accepted, define the IP Address of the ATLAS 810PLUS to which you want to connect. The following Step/Ac- tion chart describes this process.

	Instructions for Defining the IP Address
Step	Action
1	Obtain an IP address for the ATLAS 810PLUS from your LAN
	administrator.
	Use the ADTRAN-provided VT-100 terminal adapter to connect
	the COM port of a VT-100 compatible terminal, or equivalent, to
2	the eight-pin modular jack labeled CONTROL/CHAIN IN on the
	rear panel or labeled CRAFT on the front panel.
	This connection provides both local and remote configuration.
3	Repeatedly press System on the front panel until the Login
	menu appears. Enter your password.
4	When the terminal menu opens, navigate the following path:
	ATLAS 810PLUS / System Config / Ethernet port / IP Address
5	Key in the entire IP address, and then press Enter.

You will need a default gateway if the LAN contains multiple segments. Contact your LAN administrator for the appropriate address.

3-2 ATLAS 810PLUS User Manual 61200266L1-1