Chapter 9. Dial Plan Terminal Menu

»»Outgoing Caller ID Write Security: 3 Read Security: 5

Allows the user to insert a called ID to outgoing calls (coming in from attached User equipment). If set to 6HQGýDVý3URYLGHG, then ATLAS will for- ward whatever ID it receives (including none). If set to 6XEVWLWXWHýLIýQRWý SUHVHQW, then ATLAS inserts a User-defined ID value if no value is received. If set to 6XEVWLWXWHý$OZD\V, then ATLAS always inserts the User-defined ID in place of the value received.

»ID Presentation Defines control information for the presentation of Caller ID (3UHVHQWDWLRQý $OORZHGâý3UHVHQWDWLRQý5HVWULFWHGâý1XPEHUý1RWý$YDLODEOH).

» ID Number

Value for Caller ID to be sent to the Network (i.e., 256 963 8020).

» Source ID

Simplifies the creation of a Dial Plan in applications where the criterion for

 

switching calls to a certain endpoint is a function of which endpoint origi-

 

nated the call.

 

• Default value = 0. The default ID for all endpoints is 0 and all accept # s

 

is 0. With default values, all calls are routed based only on dialed num-

 

ber.

 

• Multiple endpoints can have the same Source ID.

 

• When creating the Call Accept list, specify a Source ID(s) as well as a di-

 

aled number or range of dialed numbers to accept.

 

For example, an application requires that all calls originating from Port 1 of

 

the Quad T1/PRI module in Slot 1 be switched to Port 4 of that same mod-

 

ule. Assign a unique Source ID (e.g., 7) to Port 1 of the module, and then

 

configure Port 4 to only accept calls from that unique Source ID (7).

»» Swap ANI/DNIS

Swaps the ANI and DNIS numbers prior to being forwarded to the attached

 

user equipment. ANI (Automatic Number Identification) is the billing

 

number of the calling party, and DNIS (Dialed Number Identification Ser-

 

vice) is the called party number.

 

 

 

This swap occurs after the ATLAS switchboard has routed the call.

 

The accept number in the Dial Plan must use the number in the

 

DNIS position prior to swapping.

 

 

Quad T1/PRI Module (User Termination/NFAS)

 

When you are working in the User Termination section of the Dial Plan

 

menu, Slot is defined as a T1/PRI module, and Sig is set to NFAS, the fol-

 

lowing configuration menu is available (in addition to the standard User

 

Termination/PRI configuration menus and options):

» Secondary

Write security: 3; Read security: 5

Interfaces

Defines the additional PRI interfaces controlled by the D-channel on this

 

endpoint.

» Slot, Port

Write security: 3; Read security: 5

 

Defines the slot and port in which the additional interface terminates.

61200266L1-1

ATLAS 810PLUS User Manual

9-17

Page 111
Image 111
ADTRAN 810 Plus manual Quad T1/PRI Module User Termination/NFAS, » ID Number, » Source ID