ADTRAN 810 Plus manual Service Type, 04DU9-ISN RJ-48C

FCC regulations require that the following information be provided in this manual to the customer:

1.This equipment complies with Part 68 of the FCC rules. The required label is affixed to the bottom of the chassis.

2.An FCC-compliant telephone cord with a modular plug is provided with this equipment. This equipment is designed to be connected to the telephone network or premises wiring using a com- patible modular jack which is Part 68-compliant. See Chapter 2, Installation, for details.

3.If your telephone equipment (ATLAS) causes harm to the telephone network, the telephone com- pany may discontinue your service temporarily. If possible, they will notify you in advance. But if advance notice isn’t practical, you will be notified as soon as possible. You will be advised of your right to file a complaint with the FCC.

4.Your telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the proper operation of your equipment. If they do, you will be given advance notice to give you an opportunity to maintain uninterrupted service.

5.If you experience trouble with this equipment (ATLAS), please contact ADTRAN at (256) 963-8000 for repair/ warranty information. The telephone company may ask you to disconnect this equip- ment from the network until the problem has been corrected or until you are sure the equipment is not malfunctioning.

6.This unit contains no user-serviceable parts.

7.The following information may be required when applying to your local telephone company for leased line facilities.

	Service Type	REN/SOC	FIC	USOC
1.544	Mbps - SF	6.0N	04DU9-BN	RJ-48C
1.544	Mbps - SF and B8ZS	6.0N	04DU9-DN	RJ-48C
1.544	Mbps - ESF	6.0N	04DU9-1KN	RJ-48C
1.544	Mbps - ESF and B8ZS	6.0N	04DU9-1SN	RJ-48C
ISDN		6.0N	04DU9-ISN	RJ-48C

Federal Communications Commission Radio Frequency Interference Statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pur- suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference# when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio frequencies. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Shielded cables must be used with this unit to ensure compliance with Class A FCC limits.

Change or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

iv