Chapter 6. Terminal Menu and System Control
» BONDING Config
»»TXINIT Timer (sec) This option specifies the length of time the originating endpoint attempts to detect the BONDING negotiation pattern from the answering endpoint be- fore deciding the BONDING call has failed.
»»TXFA Timer (sec) This option specifies the length of time both endpoints attempt to detect the BONDING frame pattern when a call is connected before deciding the BONDING call has failed. When interoperating with other manufacturers’ BONDING equipment, it may be necessary to change this time so that it matches TXADD01.
»»TXADD01Timer (sec) This option specifies the length of time both endpoints wait for the addition- al calls to be connected at the end of negotiation before deciding the BOND- ING call has failed. The factory default setting is sufficient for most calls to connect, although when dialing overseas, it may be necessary to lengthen this timer to allow for slower call routing.
»»TXDEQ Timer (sec) This option specifies the length of time both endpoints attempt to equalize the network delay between the bearer channels before deciding the BOND- ING call has failed.
»»TANULL Timer (sec) This option specifies the length of time the answering endpoint attempts to detect the BONDING negotiation pattern from the originating endpoint be- fore aborting the clear channel mode. It may be necessary to shorten this time if the DTE equipment using the BONDING module also has timer con- straints for completing
»»TCID Timer (sec) This option specifies the length of time both endpoints attempt to negotiate an agreeable value for bearer channels and channel capacities before decid- ing the BONDING call has failed.
»» Call Stagger | This option specifies the amount of delay placed between calls. Options in- |
| clude No Stagger, 100 ms, 200 ms, 500 ms, 1 sec, and 2 sec. |
»Alarm Relay Reset Clears the Alarm Relay located on the rear panel of the ATLAS 810PLUS.
» Alarm Relay | Logs Event Thresholds necessary to set Alarm Relay. These thresholds in- |
Threshold | clude Critical, Major, Minor, Warning, and Normal. |
ATLAS 810PLUS User Manual |
