Agilent Technologies 1670G manual

DATA
Command :SYSTem:DATA <block_data>
The DATA command allows you to send and receive acquired data to and
from a controller in block form. This helps saving block data for:
•Reloading to the logic analyzer
•Processing data later in the logic analyzer
•Processing data in the controller
The format and length of block data depends on the instruction being used
and the configuration of the analyzer. This chapter describes briefly the
syntax of the Data command and query. See chapter 27, "DATA and SETup
Commands" for additional information.
Example OUTPUT XXX;":SYSTEM :DATA" <block_data >
<block_data> <block_length_specifier><section>
<block_length_
specifier> #8<length>
<length> The total length of all sections in byte format (must be represented with 8
digits)
<section> <section_header><section_data>
<section_
header> 16 bytes, described in the "Section Header Description" section in chapter 27, "DATA and SETup Commands."
<section_data> The format depends on the type of data
SYSTem Subsystem
DATA
11–5