Introduction
The State Chart subsystem provides the commands necessary for
programming the Agilent 1670G-series logic analyzer State Chart
display. The commands allow you to build charts of label activity,
using data normally found in the Listing display. The chart’s Y axis is
used to show data values for the label of your choice. The X axis can
be used in two different ways. In one, the X axis represents states
(shown as rows in the State Listing display). In the other, the X axis
represents the data values for another label. When states are plotted
along the X axis, X and O markers are available. Because the State
Chart display is simply an alternative way of looking at the data in the
State Listing, the X and O markers can be manipulated through the
SLISt subsystem. Because the programming commands do not force
the menus to switch, you can position the markers in the SLISt
subsystem and see the effects in the State Chart display.
The commands in the SCHart subsystem are:
•ACCumulate
•CENTer
•HAXis
•VAXis
19–2