Agilent Technologies 1670G Selecting the Pattern Generator

Line 30 assigns label ’A’, positive polarity and assigns the seven least
significant bits of pod 5
Line 40 assigns label ’B’ and assigns all eight bits of pod 4
Line 50 removes all program lines
Line 60 inserts a new line (after line 0) in the INIT SEQUENCE portion of the
program.
Line 70 inserts a new line (after line 4) in the MAIN SEQUENCE portion of
the program. Recall that the default MAIN SEQUENCE already has two lines
of program
Line 80 Sets the RMODE to repetitive. If the program is to be run only once,
select the :RMODE SINGLE command.
Line 90 Starts the program.
Selecting the Pattern Generator
Before you can program the pattern generator, you must first "select" it,
otherwise, there is no way to direct your commands to the pattern generator.
To select the pattern generator, use this command:
:SELect 2
Programming the Pattern Generator
Selecting the Pattern Generator
37–4