Agilent Technologies 6814B, 6834B INITiate:CONTinuous:SEQuence, INITiate:CONTinuous:NAME, TRIGger

Language Dictionary - 3

INITiate:CONTinuous:SEQuence

INITiate:CONTinuous:NAME

These commands control the transient generator trigger system as follows:

1 or ON Continuously initiates the transient trigger system.

0 or OFF Turns off continuous triggering. In this state, the trigger system must be initiated for each triggered event using INITiate:SEQuence.

INITiate:CONTinuous:SEQuence references the transient trigger sequence by its number, while INITiate:CONTinuous:NAME references it by its name.

Command Syntax

Parameters

Examples

Related Commands

INITiate:CONTinuous:SEQuence[1] <Bool> INITiate:CONTinuous:NAME TRANsient, <Bool>

0 1 OFF ON
INIT:CONT:SEQ ON	INIT:CONT:NAME TRAN, 1
ABOR INIT:CONT	TRIG *TRG

TRIGger

When the trigger subsystem has been initiated, the TRIGger command generates a trigger signal regardless of the selected trigger source.

Command Syntax	TRIGger[:SEQuence1][:IMMediate]
	TRIGger[:TRANsient][:IMMediate]
Parameters	None
Examples	TRIG	TRIG:TRAN	TRIG:SEQ1:IMM
Related Commands	ABOR	TRIG:SOUR	TRIG:DEL TRIG:SYNC

TRIG:SYNC:PHAS INIT INIT:CONT *TRG WAI

TRIGger:DELay

This command sets the time delay between the detection of a trigger signal and the start of any corresponding trigger action. After the time delay has elapsed, the trigger is implemented unless the trigger system is also waiting for a sync signal that has been specified by TRIGger:SYNChronous:PHASe.

Command Syntax

Parameters

Unit

*RST Value

Examples

Query Syntax

Returned Parameters Related Commands

TRIGger[:SEQuence1]:DELay <NRf+>

TRIGger[:TRANsient]:DELay <NRf+>

3-phase models: 0 to 1.07533E6 MINimum MAXimum

1-phase models: 0 to 4.30133E5 MINimum MAXimum

S (seconds)
0
TRIG:DEL .25	TRIG:DEL MAX	TRIG:TRAN:DEL 1

TRIGger[:SEQuence1]:DELay?

TRIGger[:TRANsient]:DELay?

<NR3>

ABOR TRIG TRIG:SOUR TRIG:SYNC TRIG:SYNC:PHAS INIT INIT:CONT *TRG WAI

109