Agilent Technologies 6812B, 6834B, 6814B, 6843A OUTPut:RI:MODE, OUTPut TTLTrg SOURce, Outp:Ttlt

Language Dictionary - 3

OUTPut:RI:MODE

This command selects the mode of operation of the Remote Inhibit protection. The following modes can be selected:

LATChing	A TTL low at the RI input latches the output in the protection shutdown state, which can
	only be cleared by OUTPut:PROTection:CLEar.
LIVE	The output state follows the state of the RI input. A TTL low at the RI input turns the output
	off; a TTL high turns the output on.
OFF	The instrument ignores the RI input.
	Command Syntax	OUTPut:RI:MODE <mode>
	Parameters	LATChing LIVE OFF
	*RST Value	LATChing
	Examples	OUTP:RI:MODE LIVE
	Query Syntax	OUTPut:RI:MODE?
Returned Parameters		<CRD>
Related Commands		OUTP:PROT:CLE

OUTPut:TTLTrg

This command enables or disables the ac source Trigger Out signal, which is available at a BNC connector on the rear of the instrument.

Command Syntax	OUTPut:TTLTrg[:STATe] <bool>
Parameters	0 1 OFF ON
*RST Value	OFF
Examples	OUTP:TTLT 1	OUTP:TTLT ON
Query Syntax	OUTPut:TTLTrg[:STATe]?
Returned Parameters	0 1
Related Commands	OUTP:TTLT:SOUR

OUTPut:TTLTrg:SOURce

This command selects the signal source for the Trig Out signal as follows:

BOT	Beginning of transient output
EOT	End of transient output
LIST	Specified by the TTLTrg list

When an event becomes true at the selected TTLTrg source, a pulse is sent to the BNC connector on the rear of the ac source.

Command Syntax	OUTPut:TTLTrg:SOURce <source>
Parameters	BOT EOT LIST
*RST Value	BOT
Examples	OUTP:TTLT:SOUR LIST
Query Syntax	OUTPut:TTLTrg:SOURce?
Returned Parameters	<CRD>
Related Commands	OUTP:TTLT

59