Agilent Technologies 6834B, 6814B CALibrate:CURRent:MEASure, CALibrate:DATA, CALibrate:IMPedance

3 - Language Dictionary

CALibrate:CURRent:MEASure

Agilent 6811B, 6812B, 6813B, 6843A Only

This command is used to initiate the calibration of the current metering circuits and the peak current limit circuits. It can only be used in the calibration mode.

Command Syntax	CALibrate:CURRent:MEASure
Parameters	None
Examples	CAL:CURR:MEAS
Related Commands	CAL:STAT CAL:SAV CAL:LEV

CALibrate:DATA

Phase Selectable

This command is only used in calibration mode. It enters a calibration value that you obtain by reading an external meter. You must first select a calibration level (with CALibrate:LEVel) for the value being entered. These constants are not stored in nonvolatile memory until they are saved with CALibrate:SAVE. If CALibrate:STATE OFF is programmed without a CALibrate:SAVE, the previous calibration constants are restored.

Command Syntax	CALibrate:DATA <NRf>
Parameters	<external reading>
Unit	A (amperes)
Examples	CAL:DATA	3222.3 MA	CAL:DATA 5.000
Related Commands	CAL:STAT	CAL:SAV

CALibrate:IMPedance

Agilent 6811B, 6812B, 6813B, 6843A Only

This command can only be used in calibration mode. It calibrates the output impedance circuits. The automatically performs the calibration and stores the impedance constant in nonvolatile memory. CALibrate:IMPedance is a sequential command that takes several seconds to complete.

Command Syntax	CALibrate:IMPedance
Parameters	None
Examples	CAL:IMP
Related Commands	CAL:STAT CAL:SAV

CALibrate:LEVel

Phase Selectable

This command can only be used in calibration mode. It is used to advance to the next state in the calibration sequence.

Command Syntax CALibrate:LEVel <level>

Parameters P1 P2 P3 P4

Examples CAL:LEV P2

Related Commands CAL:STAT CAL:SAV

30