Agilent Technologies 6811B Source Subsystem Pulse, PULSe:COUNt, PULSe:DCYCle, Subsystem Syntax

3 - Language Dictionary

Source Subsystem (Pulse)

This subsystem controls the generation of output pulses. The PULSe:DCYCle, PULSe:HOLD, PULSe:PERiod, and PULSe:WIDTh commands are coupled, which means that the values programmed by any one of these commands can be affected by the settings of the others. Refer to the tables under PULSe:HOLD for an explanation of how these commands affect each other.

Subsystem Syntax

[SOURce:]
PULSe
:COUNt <n> INFinity	Selects transient pulse count
:DCYCle <n>	Selects pulse duty cycle
:HOLD <parameter>	Selects parameter that is held constant (WIDTh DCYCle)
:PERiod <n>	Selects pulse period when the count is greater than 1
:WIDTh <n>	Selects width of the pulses

PULSe:COUNt

This command sets the number of pulses that are output when a triggered output transient occurs. The command accepts parameters in the range 1 through 9.9E37. If INFinity or MAXimum is sent, the output pulse repeats indefinitely.

Command Syntax

Parameters

*RST Value

Examples

Query Syntax

Returned Parameters

Related Commands

[SOURce:]PULSe:COUNt <Nrf+> INFinity
1 to 9.9E37 MINimum MAXimum INFinity
1
PULS:COUN 3	PULS:COUN MIN	PULS:COUN INF
[SOURce:]PULSe:COUNt?
<NR3>
PULS:DCYC	PULS:HOLD PULS:PER	PULS:PER

PULSe:DCYCle

This command sets the duty cycle of the triggered output pulse. The duty cycle units are specified in percent.

Command Syntax	[SOURce:]PULSe:DCYCle <Nrf+>
Parameters	0 to 100 (percent) MINimum MAXimum
*RST Value	50
Examples	PULS:DCYC 75	PULS:DCYC MAX
Query Syntax	[SOURce:]PULSe:DCYCle?
Returned Parameters	<NR3>
Related Commands	PULS:COUN	PULS:HOLD PULS:PER PULS:WIDT

82