Agilent Technologies 6812B Calibration Subsystem Commands, Subsystem Syntax, CALibrate CURRent AC

Language Dictionary - 3

Calibration Subsystem Commands

The commands in this subsystem allow you to do the following:

υEnable and disable the calibration mode

υChange the calibration password

υCalibrate the current and voltage output levels, and store new calibration constants in nonvolatile memory.

Subsystem Syntax

CALibrate
:CURRent
:AC	Begin ac current programming calibration sequence
:MEASure	Begin current measurement calibration sequence
:DATA <n>	Input a calibration measurement
:IMPedance	Begin output impedance calibration sequence
:LEVel <level>	Advance to next calibration step (P1 P2 P3 P4)
:PASSword <n>	Set calibration password
:PWM
:FREQuency <n>	Trim pulse width modulator frequency
:RAMP <n>	Trim pulse width modulator ramp
:SAVE	Save new cal constants in non-volatile memory
:STATE <bool> [,<n>]	Enable or disable calibration mode
:VOLTage
:AC	Begin ac voltage calibration sequence
:DC	Begin dc voltage calibration sequence
:OFFSet	Begin offset voltage calibration sequence
:PROTection	Begin voltage protection calibration sequence
:RTIMe	Begin realtime voltage calibration sequence

CALibrate:CURRent:AC

Phase Selectable

This command can only be used in the calibration mode. It initiates the calibration of the ac current limit and metering circuits.

Command Syntax	CALibrate:CURRent:AC
Parameters	None
Examples	CAL:CURR:AC
Related Commands	CAL:STAT CAL:SAV CAL:LEV

29