Agilent Technologies 6843A, 6834B OUTPut:COUPling, OUTPut:DFI:SOURce, Outp:Coup Dc, Outp:Dfi

3 - Language Dictionary

OUTPut:COUPling

Agilent 6811B, 6812B, 6813B, Only

This command enables ac or dc output coupling. When the output coupling is set to AC, a dc leveling loop attempts to maintain zero average output voltage. The loop has a corner frequency of about 2Hz. It will not prevent short transient waveforms that may have non-zero average voltage, but will cause a settling transient to an average value of 0 volts.

The output coupling must be set to DC to obtain dc output with VOLTage:OFFSet, or to generate output transients that have net dc components.

Command Syntax	OUTPut:COUPling <coupling>
Parameters	AC DC
*RST Value	AC
Examples	OUTP:COUP DC
Query Syntax	OUTPut:COUPling?
Returned Parameters	<CRD>
Related Commands	*RCL *SAV

OUTPut:DFI

This command enables or disables the discrete fault indicator (DFI) signal to the ac source.

Command Syntax	OUTPut:DFI[:STATe] <bool>
Parameters	0 1 OFF ON
*RST Value	OFF
Examples	OUTP:DFI 1	OUTP:DFI ON
Query Syntax	OUTPut:DFI[:STATe]?
Returned Parameters	0 1
Related Commands	OUTP:DFI:SOUR

OUTPut:DFI:SOURce

This command selects the source for DFI events. The choices are:

QUEStionable	Questionable summary bit
OPERation	Operation summary bit
ESB	Standard Event summary bit
RQS	Request Service summary bit
OFF	Never true

Command Syntax

Parameters

*RST Value

Examples

Query Syntax

Returned Parameters

Related Commands

OUTPut:DFI:SOURce <source> QUEStionable OPERation ESP RQS OFF OFF

OUTP:DFI:SOUR OPER

OUTPut:DFI:SOURce?

<CRD>

OUTP:DFI

56