Agilent Technologies 6811B, 6834B, 6814B, 6843A, 6813B manual LISTTTLTrgPOINts?, Liststep Once

3 - Language Dictionary

LIST:STEP

This command specifies how the list sequencing responds to triggers. The following parameters may be specified:

ONCE

AUTO

causes the list to advance only one point after each trigger. Triggers that arrive during a dwell delay are ignored

causes the entire list to be output sequentially after the starting trigger, paced by its dwell delays. As each dwell delay elapses, the next point is immediately output

Command Syntax	[SOURce:]LIST:STEP <step>
Parameters	ONCE AUTO
*RST Value	AUTO
Examples	LIST:STEP ONCE
Query Syntax	[SOURce:]LIST:STEP?
Returned Parameters	<CRD>
Related Commands	LIST:COUN LIST:DWEL

LIST:TTLTrg

This command sets the sequence of Trigger Out list points. Each point which is set ON will cause a pulse to be output at Trigger Out when that list step is reached. Those entries which are set OFF will not generate Trigger Out pulses.

The order in which the list points are given determines the sequence in which Trigger Out pulses will be output when a list is triggered. Changing list data while a subsystem is in list mode generates an implied ABORt.

Command Syntax	[SOURce:]LIST:TTLTrg <bool> {,<bool>}
Parameters	0 1 OFF ON
Examples	LIST:TTLT 1,0,1	LIST:TTLT ON,OFF,ON
Query Syntax	[SOURce:]LIST:TTLTrg?
Returned Parameters	0 1 {,0 1}
Related Commands	LIST:TTLT:POIN?	LIST:COUN LIST:DWEL LIST:STEP

OUTP:TTLT OUTP:TTLT:SOUR

LIST:TTLTrg:POINts?

This query returns the number of points specified in LIST:TTLT. Note that it returns only the total number of points, not the point values.

Query Syntax [SOURce:]LIST:TTLTrg:POINTs?

Returned Parameters <NR1>

Examples LIST:TTLT:POIN?

Related Commands LIST:TTLT

76