AT-TQ2450 Wireless Access Point User’s Guide
33
The Static IP Address, Subnet Mask, and Default Gateway fields in the
window are activated so that you can change their values.
3. Select the Static IP Address field and enter the new IP address for the
access point. The default address is 192.168.1.230.
4. Select the Subnet Mask fields and enter the subnet mask for the IP
address. The default subnet mask is 255.255.255.0.
5. Select the Default Gateway fields and enter the default gateway
address for the unit. The default gateway address is 192.168.1.254.
The default gateway is an IP address of an interface on a router or
other Layer 3 routing device. It specifies the first hop to reaching the
subnets or networks where your management devices, such as
management workstations and syslog servers, reside. The access
point can have only one default gateway and the network portion of the
address must be the same as the IP address entered in step 3.
You have to assign a default gateway to the access point. If your
network does not have a default gateway or you do not want to assign
one to the access point at this time, enter an unused IP address of the
same network as the IP address entered in step 3.
6. If you want to specify the IP addresses of Domain Name servers, enter
up to two IP addresses in the DNS Nameservers fields. If you have
only one DNS IP address, you must enter it in the top field.
7. Click the Update button at the bottom of the window to activate and
save your changes on the access point.
Your management session is interrupted.
8. Start a new management session using the new IP address of the
device.