AT-TQ2450 Wireless Access Point User’s Guide
81
Figure 25. Configure Pre-Configured Rogue AP Window
2. Click the Enabled dialog circles for the AP Detection for Radio options.
Radios 1 and 2 are the 2.4 and 5 GHz radios, respectively.
You may activate one or both radio detections. If you are only
interested in receiving event messages of unknown access points on
one radio, activate that radio detection. If you are interested in
receiving event messages for both radios, enable both options.
Note
You cannot configure the feature parameters until you enable at
least one of the access point detections.
3. Use the Rogue AP Interval pull-down menu to select the intervals at
which the device tests for unknown access points. The range is 15
minutes to four weeks. The default is 15 minutes.
4. If there are neighboring access points you want to add to the approved
list so that the access points does not generate event messages when
it detects them, enter the address of one of them in the fields below the
list and click the Add button. You may add only one MAC address at a
time.
5. Repeat step 4 to add more access points to the approved list. You may
add up to 200 addresses.
6. To remove a MAC address from the list, click the address and then
click the Remove button. You may delete only one address at a time
from the list.