Allied Telesis AT-TQ2450 manual Manage Menu

Chapter 3: Manage Menu

Note

If the Country pull-down menu is deactivated, the country parameter was set by the manufacturer and cannot be changed. Contact your Allied Telesis sales representative for assistance if the setting is not correct for your country or region.

The access point displays a confirmation prompt.

3.Click OK to change the country setting or Cancel to cancel the procedure.

If you click OK, the access point changes the country setting and disables both radios on the access point. For instructions on how to enable the radios and configure their settings, refer to “Configuring Basic Radio Settings” on page 39 and “Configuring the Radio Settings” on page 42.

This procedure does not require clicking the Update button.

You must now reboot the access point. The new country setting is not active until the unit is rebooted. To reboot the unit, either power off and on the unit or continue with these steps:

4.From the Maintenance menu, select Configuration.

5.Click the Reboot button in the To Reboot the Access Point section of the “Manage the Access Point’s Configuration” window.

6.When the access point displays a confirmation prompt, click OK to reboot the unit or Cancel to cancel the procedure.

7.To resume managing the unit, wait for it to complete initializing its management software and then start a new management session.

38