AMD SC1200, SC1201 manual Relevant Parallel Port Registers, Parallel Port Configuration Register

32579B SuperI/O Module

5.4.2.6LDN 07h - Parallel Port

The Parallel Port supports all IEEE 1284 standard commu- nication modes: Compatibility (known also as Standard or SPP), Bidirectional (known also as PS/2), FIFO, EPP (known also as Mode 4) and ECP (with an optional Extended ECP mode).

The Parallel Port includes two groups of runtime registers, as follows:

•A group of 21 registers at first level offset, sharing 14 entries. Three of these registers (at Offset 403h, 404h, and 405h) are used only in the Extended ECP mode.

•A group of four registers, used only in the Extended ECP mode, accessed by a second level offset.

The desired mode is selected by the ECR runtime register (Offset 402h). The selected mode determines which runt- ime registers are used and which address bits are used for the base address. (See Section 5.8.1 on page 129 for fur- ther details regarding the runtime registers.)

Table 5-15lists the configuration registers which affect the Parallel Port. Only the last register (F0h) is described here (Table 5-16). See Table 5-3 "Standard Configuration Regis- ters" on page 95 for descriptions of the others.

Table 5-15. Relevant Parallel Port Registers

			Reset
Index	Type	Configuration Register or Action	Value
30h	R/W	Activate. See also bit 0 of the SIOCF1 register.	00h
60h	R/W	Base Address MSB register. Bits [7:3] (for A[15:11]) are RO, 00000b. Bit 2 (for A10) should	02h
		be 0b.
61h	R/W	Base Address LSB register. Bits 1 and 0 (A1 and A0) are RO, 00b. For ECP Mode 4 (EPP)	78h
		or when using the Extended registers, bit 2 (A2) should also be 0b.
70h	R/W	Interrupt Number.	07h
71h	R/W	Interrupt Type.	02h
		Bits [7:2] are RO.
		Bit 1 is R/W.
		Bit 0 is RO. It reflects the interrupt type dictated by the Parallel Port operation mode. This bit
		is set to 1 (level interrupt) in Extended Mode and cleared (edge interrupt) in all other modes.
74h	R/W	DMA Channel Select.	04h
75h	RO	Report no second DMA assignment.	04h
F0h	R/W	Parallel Port Configuration register. (See Table 5-16.)	F2h

Table 5-16. Parallel Port Configuration Register

Bit

Description

Index F0h	Parallel Port Configuration Register (R/W)	Reset Value: F2h
This register is reset by hardware to F2h.
7:5	Reserved. Must be 11.

4Extended Register Access.

0:Registers at base (address)+403h, base+404h and base+405h are not accessible (reads and writes are ignored).

1:Registers at base (address)+403h, base+404h and base+405h are accessible. This option supports run-time configura- tion within the Parallel Port address space.

3:2 Reserved.

1Power Mode Control. When the logical device is active:

0:Parallel port clock disabled. ECP modes and EPP timeout are not functional when the logical device is active. Registers are maintained.

1:Parallel port clock enabled. All operation modes are functional when the logical device is active. (Default)

0TRI-STATE Control. When enabled and the device is inactive, the logical device output pins are in TRI-STATE.

0:Disable. (Default)

1:Enable.

104 AMD Geode™ SC1200/SC1201 Processor Data Book