AMD SC1201, SC1200 manual USB Controller Registers Pciusb, Pciusb USB PCI Configuration Registers

Core Logic Module - USB Controller Registers - PCIUSB 32579B

6.4.6USB Controller Registers - PCIUSB

The registers designated as PCIUSB are 32-bit registers decoded from the PCI address bits [7:2] and C/BE[3:0]#, when IDSEL is high, AD[10:8] select the appropriate func- tion, and AD[1:0] are 00.

The PCI Configuration registers are listed in Table 6-41.They can be accessed as any number of bytes within a sin- gle 32-bit aligned unit. They are selected by the PCI-stan- dard Index and Byte-Enable method.

In the PCI Configuration space, there is one Base Address Register (BAR), at Index 10h, which is used to map the

USB Host Controller's operational register set into a 4K memory space. Once the BAR register has been initialized, and the PCI Command register at Index 04h has been set to enable the Memory space decoder, these “USB Control- ler” registers are accessible.

The memory-mapped USB Controller registers are listed in Table 6-42.They follow the Open Host Controller Interface (OHCI) specification. Registers marked as “Reserved”, and reserved bits within a register, should not be changed by software.

Table 6-41. PCIUSB: USB PCI Configuration Registers

Bit

Description

Index 00h-01h		Vendor Identification Register (RO)	Reset Value: 0E11h
Index 02h-03h		Device Identification Register (RO)	Reset Value: A0F8h
Index 04h-05h		Command Register (R/W)	Reset Value: 00h
15:10	Reserved. Must be set to 0.

9Fast Back-to-Back Enable. (Read Only) USB only acts as a master to a single device, so this functionality is not needed. It is always disabled (i.e., this bit must always be set to 0).

8SERR#. When this bit is enabled, USB asserts SERR# when it detects an address parity error.

0:Disable.

1:Enable.

7Wait Cycle Control. USB does not need to insert a wait state between the address and data on the AD lines. It is always disabled (i.e., this bit is set to 0).

6Parity Error. USB asserts PERR# when it is the agent receiving data and it detects a data parity error.

0:Disable.

1:Enable.

5VGA Palette Snoop Enable. (Read Only) USB does not support this function. It is always disabled (i.e., this bit is set to 0).

4Memory Write and Invalidate. Allow USB to run Memory Write and Invalidate commands.

0:Disable.

1:Enable.

The Memory Write and Invalidate Command only occurs if the cache-line size is set to 32 bytes and the memory write is exactly one cache line.

This bit must be set to 0.

3Special Cycles. USB does not run special cycles on PCI. It is always disabled (i.e., this bit is set to 0).

2PCI Master Enable. Allow the USB to run PCI master cycles.

0:Disable.

1:Enable.

1Memory Space. Allow the USB to respond as a target to memory cycles from the PCI bus.

0:Disable.

1:Enable.

0I/O Space. Allow the USB to respond as a target to I/O cycles from the PCI bus. 0 Disable.

1:Enable.

AMD Geode™ SC1200/SC1201 Processor Data Book 283