AMD SC1201, SC1200 manual Core Logic Module Bridge, GPIO, and LPC Registers Function, Index 09h-0Bh

Core Logic Module - Bridge, GPIO, and LPC Registers - Function 0 32579B

Table 6-29. F0: PCI Header/Bridge Configuration Registers for GPIO and LPC Support (Continued)

Bit Description

4Memory Write and Invalidate. Allow the Core Logic module to do memory write and invalidate cycles, if the PCI Cache Line register (F0 Index 0Ch) is set to 32 bytes (08h).

0:Disable. (Default)

1:Enable.

3Special Cycles. Allow the Core Logic module to respond to special cycles.

0:Disable.

1:Enable. (Default)

This bit must be enabled to allow an SMI to be generated from a CPU Shutdown cycle.

2Bus Master. Allow the Core Logic module bus mastering capabilities.

0:Disable.

1:Enable. (Default)

This bit must be set to 1.

1Memory Space. Allow the Core Logic module to respond to memory cycles from the PCI bus.

0:Disable.

1:Enable. (Default)

0I/O Space. Allow the Core Logic module to respond to I/O cycles from the PCI bus:

0:Disable.

1:Enable. (Default)

This bit must be set to 1 to access I/O offsets through F0BAR0 and F0BAR1 (see F0 Index 10h and 14h).

Index 06h-07h		PCI Status Register (R/W)	Reset Value: 0280h
15	Detected Parity Error. This bit is set whenever a parity error is detected. Write 1 to clear.
14	Signaled System Error. This bit is set whenever the Core Logic module asserts SERR# active. Write 1 to clear.

13Received Master Abort. This bit is set whenever a master abort cycle occurs. A master abort occurs when a PCI cycle is not claimed, except for special cycles. Write 1 to clear.

12Received Target Abort. This bit is set whenever a target abort is received while the Core Logic module is the master for the PCI cycle. Write 1 to clear.

11Signaled Target Abort. This bit is set whenever the Core Logic module signals a target abort. This occurs when an address parity error occurs for an address that hits in the active address decode space of the Core Logic module. Write 1 to clear.

10:9	DEVSEL# Timing. (Read Only) These bits are always 01, as the Core Logic module always responds to cycles for which it
	is an active target with medium DEVSEL# timing.
	00: Fast
	01: Medium
	10: Slow
	11: Reserved.

8Data Parity Detected. This bit is set when:

1)The Core Logic module asserts PERR# or observed PERR# asserted.

2)The Core Logic module is the master for the cycle in which the PERR# occurred, and PE is set (F0 Index 04h[6] = 1).

Write 1 to clear.

7Fast Back-to-Back Capable. (Read Only) Enables the Core Logic module, as a target, to accept fast back-to-back transac- tions.

0:Disable.

1:Enable.

	This bit is always set to 1.
6:0	Reserved. (Read Only) Must be set to 0 for future use.
Index 08h		Device Revision ID Register (RO)	Reset Value: 00h
Index 09h-0Bh		PCI Class Code Register (RO)	Reset Value: 060100h

AMD Geode™ SC1200/SC1201 Processor Data Book 191