AT&T R1V2 manual Administering Voice Stations, Adding a Voice Station

Administering Voice Stations

■Assign voice terminals

■Remove voice terminals

■Assign and change station dial codes

■Assign class of service

Using the Port and PDC Menus: Class-of-service options for single-line and multiline voice terminals can be administered from either the PDC menu (Main Menu item 2) or from the Port menu (Main Menu item 1). This makes it convenient for you to administer a station based on the information you have. If you know the station PDC, use Menu 2; if you know the station location (CSSPP) but not the PDC, use Menu 1.

Adding a Voice Station

You cannot add a voice terminal to a port where a station already exists. You must first remove the existing station, then add the new station. See the procedure entitled Removing a Station.

To add a voice terminal

[AG]

1 At the Main Menu prompt, enter 1.

2 At Port = , enter the carrier/slot/port (CSSPP) for the voice terminal you’re adding. For example, enter 10608 if you want to add a voice terminal to port eight, slot six, in carrier one.

If the port is available, you see the following message:

Port not translated

3 At Action = , enter 1.

4 At Data = , enter the code for the voice terminal type you’re adding. Table 7-1 shows the code associated with each terminal type.

Note The only way to change an existing terminal type is to remove and reinstall the station.

5 Next, assign a Personal Dial Code (PDC):

You see the prompt, Action = 2.

At Data = , enter the PDC for this station. The valid range is 1-9999.

6 To administer class of service for this voice terminal, see Assigning Class of Service Options in this chapter.

Administering Voice Stations 7-1