AT&T R1V2 manual Assigning Message-Center-Like Defaults, Setting Call-Type Options

Assigning Message-Center-Like Defaults

To specify which attendant console should have message-center-like operation (for dual-SLAC systems only)

1 At Action = , enter 90.

2 At Data = , enter

■1 for the first attendant

■2 for the second attendant

■0 for neither attendant The default is 0.

Setting Call-Type Options

Follow the procedures below for each call-type priority you want to change

Note When you change a message-center-like default, the data value for Action=90 reverts to 0. The rest of the message-center-like values, the defaults (see Table 9-2) and those you’ve changed, stay the same. Do not respecify an attendant with Action=90 unless you want to revert to the original set of message-center-like defaults.

To specify a call-type	1	At Action = , enter		91.
priority	2 At Data = , enter		the call-type code, 1-8. See Table 9-1.
	3 Type a, and at		Action = , enter		9 2 .
	4 At Data = , enter		the	priority for	this call type, 0-7:

■0 = calls disallowed

■1 = highest priority, with 2, 3,...6 following

■7 = the lowest priority

The default is 4.

(continued)

9-10Administering Attendant Equipment