AT&T R1V2 manual Removing a Trunk, Assigning Class of Service to did Trunks

Removing a Trunk

To remove a trunk	1 From the Main menu prompt, enter 1.
	2 At Port = , enter the					physical port you want to remove in
		the form CSSPP.
	3	At	Action	=	, enter	1.
	4	At	Data =	,	enter 0.

Note When you remove a trunk, any Display ID associated with the trunk is also removed.

Assigning Class of Service to DID Trunks

To assign class-of-service

to a DID trunk

1 From the Main menu prompt, enter 1.

2 At Port = , enter the physical port to which you want to assign class of service.

3 At Action = , enter 3.

4 At Data = , enter the class-of-service code which is a number (1, 2, 3, or 4) equal to the number of digits the CO sends over this trunk. The default is 3.

Assigning Class of Service to All Other Trunks

To assign class of service	Note This section assumes that your trunks and their trunk
to all other trunks	numbers have been assigned.
	1 From the Main menu prompt, enter 1.
	2	At	Port	=	,	enter the physical port to which you want to
		assign class of service in the form CSSPP.
	3	At	Action	=	,	enter 3.
	4	At	Data	=	,	enter the trunk class of service code from the
		next table. The default is 8. For dial-in tie trunks, only
		codes 0-7 are valid.

Administering Trunks 5-3