AT&T R1V2 manual Assigning Class-of-Service Options, Assign Calling Restrictions

To move a data station to 1 From the Main Menu prompt, enter 2.

a new port

2 At PDC = , enter the DDC of the station you want to

move.

3 At Action = , enter 0.

The system displays the station’s present port assignment at Data = CSSPP

4 Type d, and at Data = , enter the new port assignment (CSSPP).

Assigning Class-of-Service Options

This section describes the class-of-service options — the calling restrictions and features — you can administer for data stations.

When assigning class-of-service options to a STARLAN CP, data port type code 1802, the default values are relevant for the first installed port on the board. Unless otherwise noted, values assigned to these action items on any of the four ports will be copied to all four ports on the STARLAN CP. Therefore, default values listed below may not apply to a STARLAN CP port, if you have previously changed that value for any port on the board.

To assign class of service 1 From the Main Menu prompt, enter 2.

to a data terminal

2 At PDC = , enter the DDC of the terminal to which you want to assign class of service.

Note If you are administering a STARLAN CP, the DDC you assign to the first port will not be copied to the other ports on the board. You will need to administer each port separately for this action.

Assign Calling Restrictions
To restrict access to	1	At	Action = , enter 3.
Central Office trunk pool	2	At	Data = , enter 1 for yes or 0 for no. The default is 0 .

8-4Administering Data Line and STARLAN CP Ports