AT&T R1V2 manual 28Save/Restore and System Restarts Menu=9, Systems Technician only

TABLE 16-28Save/Restore and System Restarts (Menu=9)

ACTION	DESCRIPTION	DATA
1	Save (Backup) translations	[1 to run]
2	Verify translations	[1 to run]
3	Restore translations	[1 to run]
10	Force a system warm start. FOR QUALIFIED	[1 to run]
	SYSTEMS TECHNICIAN ONLY
20	Force a system cold start. FOR QUALIFIED	[1 for Full Default, 2
	SYSTEMS TECHNICIAN ONLY.“ Full	for Limited Default]
	Default” cold start will reinstate all default
	values (true cold start). “Limited Default” cold

start will reinstate default values everywhere except for port boards.

*For Action=1, you need to press the PLAY and RECORD buttons, For Action=2 and Action=3, you need to press the PLAY button.

CAUTION: Action=3 will interrupt phone service for about five minutes.

TABLE 16-29RS232 Port Administration (Menu=10)

In response to “RS232=”, enter the RS232 connector (1-4) to be administered.

ACTION	DESCRIPTION	DATA
1	Reassign RS232 connector capability	[See footnote † for
1	Reassign RS232 connector capability	[0 to disconnect port or
		see footnote † for
2	Change the RETURN delay	options and defaults]
		[0-2; 0]
3	Change the baud rate	[300, 1200, 4800, 9600

See footnote † for defaults]

† The default for each Target connector is as follows:

TARGET	DEFAULT DATA (=CAPABILITY) DEFAULT BAUD RATE
1	1	(=Administration)	1200, 300 (auto-baud)
2	2	(=SMDR)	1200
3	3	(=Save/Restore Tape)	1200
4	Reserved		9600, 1200 (auto-baud)

Command Reference 16-33