AT&T R1V2 manual Assign a Direct Extension Selector Consoles

To remove an attendant

console

1 From the Main Menu prompt, enter 1.

2 At Port = , enter the CSSPP for the attendant console you’re removing.

3 At Action = , enter 1.

4 At Data = , enter 0.

You will see a warning message for each type of association the attendant console has with another station, for example, for personal lines or Night Service coverage. To go on with the action, type c each time you see the system message, c for continue, any other key for abort.

You see the following display when the attendant console is removed:

Action = 1 Data = 0.

Note When you remove an attendant console, any Display ID associated with the attendant dial code will also be removed.

Assign a Direct Extension Selector Console(s)

By default, System 25 assigns a DXS console, associated with first attendant console, to the second port on the first ATL circuit pack. Follow the procedures in this section if you want to:

■Assign a DXS console to the second attendant console

■Move the DXS console to a port other than the default port

■Remove a DXS console

To assign a DXS console at the second attendant position

1	From the Main menu prompt, enter			1.
2	At Port = , enter the CSSPP for the			second DXS console.
3	At	Action	= , enter 1.
4	At	Data =	, enter 1602 .

To move the DXS console to a port other than the default port

1 From the Main menu prompt, enter 1.

2 At Port = , enter the CSSPP for the DXS console you want to move.

3 At Action = , enter 1.

4 At Data = , enter 0 to remove the current DXS port assignment.

(continued)

9-4Administering Attendant Equipment