AT&T R1V2 manual Administering Data Line and Starlan CP Ports, Adding a Data Station

Administering Data Line and STARLAN CP Ports

Procedures in this section apply to:

■A data terminal connected to a Data Line Card (DLC) via an ADU, but not to a data terminal connected via a modem

■A STARLAN Interface Circuit Pack (STARLAN CP) in DLC-compatibility mode.

This section describes how to:

■Assign data stations to ports

■Remove data stations from ports

■Assign and change Data Dial Codes (DDCs)

■Assign class-of-service to data ports

Using the Port and PDC Menus: Class-of-service options for data terminals can be administered from either the PDC menu (Main Menu item 2) or from the Port menu (Main Menu item 1). This makes it convenient for you to administer a station based on the information you have. If you know the station DDC, use Menu 2; if you know the station location (CSSPP) but not the DDC, use Menu 1.

Adding a Data Station

You cannot add a data station to a port where a station already exists. You must first remove the existing station, then add the new station. See the procedure entitled Removing a Data Station.

To add a data terminal

[AG]

1 At the Main Menu prompt, enter 1.

2 At Port = , enter the carrier/slot/port (CSSPP) for the data terminal you’re adding. For example, enter 10608 if you want to add a station to port eight, slot six, in carrier one.

If the port is available, you see the following message:

Port not translated

3 At Action = , enter 1.

(continued)

Administering Data Line and STARLAN CP Ports 8-1