AT&T R1V2 manual Call Coverage Options

To allow toll restricted	1 At	Action = , enter 3 1 .
stations to make toll calls	2 At	Data = , enter 1 for yes or 0 for no. The default is 1 .
within your area code

Specify whether your CO	1 At Action = , enter	32.
requires you to dial “ 1”	2 At Data = , enter 1	for yes or 0 for no. The default is 1.
before dialing calls outside
your area code

Specify whether your CO requires you to dial “1” before dialing toll calls within your area code

1 At Action = , enter 33.

2 At Data = , enter 1 for yes or 0 for no. The default is 0.

To check toll restrictions on calls made over inter- PBX trunks (trunk type

805)that start with one specific digit

1 At Action = , enter 34.

2 At Data = , enter the single-digit CO access code of the other PBX, 1-9 or 0 for none. The default is 9.

Call Coverage Options

From the Main menu prompt, enter 4, then set the following

Call Coverage options:

To set call coverage	1	At	Action = , enter 40.
ringing on internal calls	2	At	Data = , enter:
		■	1 to provide call coverage ringing on internal calls.
		■	0 if you do not want to provide this call coverage
			option.

The default is 1.

4-2Administering System-Wide Options