AT&T R1V2 manual Display Support, Removing a Data Station

4 At Data = , enter the code for the data terminal you’re

adding:

■1801 for a DLC (ZTN126 or TN726)

■1802 for a STARLAN CP (ZTN84).

Note The only way to change an existing terminal type is to remove and reinstall the station.

5 Next, assign a Data Dial Code (DDC):

You see the prompt, Action = 2.

At Data = , enter the DDC for this station. The valid range is 1-9999.

6 To administer class of service for this station, see Assigning Class of Service Options in this chapter.

Display Support

To assign or remove a

DDC Display ID

1 At Action = , enter 9 0 .

2 At Data = , enter the Display ID (not more than 11 characters, enclosed in double quotes), or “” to remove the ID.

Removing a Data Station

To remove a data	Note When you remove a station, any Display ID associated
terminal	with that DDC will also be removed.
	1	From the Main Menu prompt, enter 1.
	2	At Port = , enter the CSSPP for the station you’re
		removing.
	3	At	Action	=	, enter 1.
	4	At	Data =	,	enter 0.

If this station is associated with another station(s) for a feature such as Third-Party Call Set-Up, you will see a warning message for each type of association. To go on with the action, respond to the system message, c for continue, any other key for abort. When there are no more associations with the station you want to remove, you see:

(continued)

8-2Administering Data Line and STARLAN CP Ports