AT&T R1V2 manual Delay Announcement, Type of Incoming

1 At Action = , enter 7 .

2 At Data = , enter:

■1 to select Directed Night Service

■0 to select TAAS Night Service. The default is 1.

Delay Announcement:	1 At Action = ,	enter 8.
To assign a Night Service	2 At Data = , enter 1 for		first delay announcement, 2 for
delay announcement
	second delay	announcement, or 0 for none. The default

is 0. (See the procedure for assigning Directed Night Service Delay Announcement under Administering Auxiliary Equipment.)

Type of Incoming	1 At Action = , enter 9.
Signaling (tie trunks	2 At Data = , enter 1 for Touch-Tone signals, or 0 for
only)
	Dial-Pulse signals. The default is 0.
	Note To connect this tie trunk directly to another PBX, see the
	“Port Options” table in Command Reference.

Pooled Trunk Hunting For outgoing calls, each trunk in a trunk group is selected in a

Order: {Read Only}certain sequence. The value returned from this action/data pair tells you what position in the list this trunk occupies (e.g., first, second, third...). The order in which trunks are used is the reverse of the order in which the trunks were assigned. For example, if you installed four trunks in the order 1, 2, 3, and 4, those trunks would be used in the order 4, 3, 2, and 1.

1 At Action = , enter 10. Data shown (1, 2, etc.) is the order in which that particular trunk will be used (1st, 2nd, etc.).

5-6Administering Trunks