AT&T R1V2 manual Assign a Switched Loop Attendant Console, Assign a Second Attendant Console

Direct Extension Selector (DXS) Console System 25 assigns by default a selector (DXS) console, associated with the first attendant console, to the second ATL port in the system. Therefore, if you do not have a DXS console, you need to remove the default assignments before you can reassign this port.

Assign a Switched Loop Attendant Console

To replace the default

DTAC with a SLAC

1From the Main Menu prompt, enter 1.

2At Port = , enter the default port assignment for the attendant console (CSSPP).

3At Action = , enter 1 .

4At Data = , enter 0 .

5You will see several warning messages for feature associations the attendant console has with other stations. Each message ends with c to continue, any other key to abort. Type c for each of these until you see the message,

Action = 1 Data = 0

6Type d and at Data = , enter 3 1 0 .

7Now reenter the attendant console PDC (since the default PDC [200] was removed in step 5 above).

Type a and at Action = , enter 2 .

8At Data = , enter the PDC for the attendant.

Assign a Second Attendant Console

To assign a second	1 From the Main menu, enter 1 .
attendant console (DTAC	2 At Port = , enter the		CSSPP for the second attendant
or SLAC; same type as
		console.
the first console) [AG]
	3
		At Action = , enter	1.
	4	At Data = , enter

■309 for a DTAC

■310 for a SLAC

5 You see the prompt, Action = 2.

6 At Data = , enter the PDC for the second attendant console.

9-2Administering Attendant Equipment